Slave element¶

The slave elements represent the power circuit devices such the main contactors from power contactors. The slave elements also represent the auxiliary contactors. Even if an auxiliary contactor is part of the command circuit, its activation is forced by another element.

Figure: QElectroTech slave element¶

For slave element exist two type of variables, the general variables that are common for all type of elements and managed internally by QElectroTech, and the specific variables for this type of element.

QElectroTech does not allow defining variable values for slave element. QElectroTech does also not allows defining new variables. QElectroTech allows only displaying the specific variables at dynamic texts.

General variables

% {F}: Label from the folio where the element can be found

% {f}: Number from the folio where the element can be found

% {M}: Plant variable from the folio where the element can be found

% {LM}: Location variable of the folio where the element can be found

% {l}: Folio line number from the workspace where the element can be found

% {c}: Folio column number from the workspace where the element can be found

% {id}: Folio position in the project (Schema number)

Specific variables

Position master element: Internal pre-defined variable which is automatically displayed under dinamic texts of the element. The default formula from the variable is (%id-%l%c), variables took from master element.

Table Of Contents

Slave element¶