Table Of Contents

Cross references settings

QElectroTech provides the option to storage at the Data from the application some project properties pre-defined by the user. This feature allows the user avoiding to define many project properties each time that the user creates new projects.

The Cross references tab from New project settings section allows pre-defining some cross references properties:

  • Cross references type (Coil, organ of protection or Switch/button).

  • Cross references label

  • Representation position cross references label (Under the label of the element or Footer).


Figure: QElectroTech New project cross references settings

To define cross references settings:

  1. Display QElectroTech settings PopUP window.

  2. Go to New project section.

  3. Go to Cross references tab.

  4. Define the desired parameters for each field.

  5. Press OK button to save the configuration changes and close settings PopUP window.


All pre-defined cross references properties defined at QElectroTech settings PopUP window will be automatically defined during project creation at project properties. The cross references properties can be found at Cross references tab tab from New folio section.